How to Create a Wooden Magazine Rack with an Angled Design
A wooden magazine rack with an angled design is a stylish and functional addition to any living space. This DIY project is ideal for beginners and experienced woodworkers alike, offering an opportunity to showcase craftsmanship while creating a practical storage solution. This guide will walk you through the step-by-step process of making an angled wooden magazine rack, covering materials, tools, cutting, assembly, and finishing.
Materials and Tools Required
Materials:
- ¾-inch plywood or solid hardwood (oak, walnut, or pine)
- Wood glue
- Wood screws (1 ¼ inch)
- Finishing nails (optional)
- Sandpaper (120-220 grit)
- Wood stain or paint
- Clear polyurethane (optional for protection)
Tools:
- Table saw or circular saw
- Miter saw
- Drill and screwdriver
- Clamps
- Measuring tape
- Pencil
- Wood filler
- Paintbrush or rag for finishing
Step 1: Designing the Magazine Rack
The angled design of the rack allows for easy access to magazines while maintaining an elegant aesthetic. You will need:
- Two side panels (angled for a sleek look)
- A bottom panel
- A back panel
- Two front rails to hold magazines
A typical dimension for a compact magazine rack is 16 inches wide, 12 inches tall, and 8 inches deep, but you can adjust based on your preference.
Step 2: Cutting the Wood Pieces
Side Panels (2 pieces)
- Use a miter saw to cut the side panels with an angled top edge. A 10-15° angle works well for an attractive slant.
- Mark and cut the bottom edges at a 90° angle for stability.
Bottom Panel
- Cut a rectangular piece that fits between the side panels. 16″ wide x 8″ deep is a good starting size.
Back Panel
- Cut a back panel that spans the width and height of your magazine rack. 16″ wide x 10″ high should work, with the top cut at an angle matching the side panels.
Front Rails (2 pieces)
- These will hold magazines in place. Cut two thin strips (1 ½ inches wide) that are the same width as the rack.
Step 3: Assembling the Frame
Attach the Bottom Panel to the Side Panels
- Apply wood glue along the edges of the bottom panel and position it between the side panels.
- Clamp the pieces together and secure them using wood screws or finishing nails.
Attach the Back Panel
- Align the back panel with the side and bottom panels, ensuring the top follows the angled cut.
- Secure with wood glue and screws.
Install the Front Rails
- Position the front rails at an angle that allows magazines to rest comfortably. Typically, spacing them 3-4 inches apart works well.
- Use glue and finishing nails to attach them to the side panels.
Step 4: Sanding and Finishing
- Use 120-grit sandpaper to smooth all surfaces, then finish with 220-grit for a refined look.
- Apply wood filler to any gaps or screw holes, then sand again once dry.
- Choose a wood stain or paint for the desired finish. Apply using a brush or rag, following the grain of the wood.
- Once dry, apply polyurethane for durability and protection.
Step 5: Final Assembly and Mounting (Optional)
- If you want to mount the rack on a wall, install D-rings or keyhole brackets on the back panel.
- Alternatively, place the magazine rack on a table, floor, or beside a sofa for easy access.
Conclusion
Building an angled wooden magazine rack is a rewarding woodworking project that enhances your space while improving organization. Whether you keep it natural with a wood stain or paint it to match your décor, this handmade rack will be both a stylish and practical addition to your home.
For more woodworking plans and step-by-step guides, check out Teds Woodworking Course here: https://5ec0fkma1rtoqesrt51ay-tfcv.hop.clickbank.net.